Dual Row 80-Pin MT Header (5PCS)
You will need the pin header for FTA, non FTA, router, cable modem JTAGGING.
You also need this for JP1/1.1/1.2/1.3 code downloading or uploading. All of our products provide minimum amount of pin headers, however if you have many devices to work with, you may need extra pin headers. This is standard 0.025" (0.64mm)square post MT header. 0.1" (2.54mm) spacing with 0.24" (6.06mm) post and 0.12" (3.00mm) tail. Can be soldered on JP1 enabled remotes (the remote control must have 6 holes) or JTAG enabled devices (the JTAG enabled devices must have hole available).
For JP1 remotes, snap two pieces of 3-pins and solder them on your remote. Depends on your JTAG enabled device, you may need to snap to two pieces of 5-pins/6-pins/7-pins/8-pins/10-pins and solder them on the PCB board. 80 pins (dual row), snappable.
DIYGADGET © 2006 - 2020