TIAO USB Multi-Protocol Adapter Lite (JTAG, SPI, I2C, Serial)

Product Code: TUMPA-Lite
Availability: In Stock
$29.99

This TIAO USB Multi-Protocol adapter is powered by FTDI's flagship communication chip FT232H.


It supports the following protocols: JTAG, SPI, I2C and serial. 


This board can support voltage from 3.3v to 5.0v.


Supported softwares:

  • Openocd
  • Urjtag
  • FlashRom
  • jtag pro
  • zJTAG - Windows console JTAG application to debrick wireless routers
  • XC3SPROG - Windows / Linux console application to program CPLD/FPGA

Package Content: 

  • TIAO USB Multi-Protocol Adapter Lite
  • Dual Row 2x40 pin 2.54mm header (3 PCS, headers are NOT presoldered on the board)
  • Female to Female Solderless Flexible JTAG Jumper Cable Wires (Length: 20cm, 8 PCS)


Technical Specificatons:

  • USB 2.0 Hi-Speed (480Mb/s)
  • JTAG / IEEE 1149.1 compatible.
  • JTAG Baudrate up to 30Mbits/sec (programmable)
  • JTAG signals are 5V to 3.3V tolerant
  • ARM Muli-ICE 20-pin header compatible.
  • Separate SPI/I2C/Serial interfaces
  • 4 on-board LEDs / PWR, ext PWR, TX and RX
  • 1 2x10 20 PIN JTAG header
  • 1 2x3 6 PIN SPI 2.54mm IDC header
  • USB Hot-Plug / JTAG Hot-Plug.
  • USB over-current protection via on-board resetable fuse.
  • Strong ESD protection on USB signals.
  • Based on the FTDI FT232H USB device.
  • Designed for FTDI MPSSE easy-to-use.
  • Free drivers for Linux.
  • Free drivers for Windows XP, Windows Vista and Windows 7/10 * Support both 32 bit and 64 bit operating systems
  • Board dimension: 76.1mm X 48.6mm

You can use this USB based multi-protocol adapter lite to JTAG your router, cable modem or any JTAG/SPI devices. Fo

Manual

Driver

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha